Media Library / Images

ZVA Slimline 2, ZVA Slimline 2 GR (Special type with PowerPerformer)

LPG Autogas Adapter (filler inlet) ACME

ACME thread 1 3/4"

FGN 3" SS

Flange with male thread, stainless steel

Section view of a DRIP STOP spout

for ZVA Slimline 2 nozzles - stops dripping Diesel

Simultaneous Refuelling/Filling of Diesel and AdBlue®

Picture 1

Tank container, Antarctica: HD-LT hose assembly, ZVF 25 LT nozzle

Low Temperature types

Elaflon Plus FEP hose assemblies, SBC Safety Breakaway Couplings

LPG road tanker loading with MannTek SBC Safety Breakaway Couplings

Bonding Reel grey, high visibility bonding cable

ZVG 2 K (Korea)

LPG nozzle for vehicle refuelling with liquefied petroleum gas (propane, butane and mixtures) up to 50 l / min. Working pressure 25 bar. Test pressure 40 bar. Burst pressure > 100 bar. Temperature range - 25° up to + 70° C, 'LT'-Type down to - 40° C.

IBC

with CHS chemical hose assembly

Solvent filling with integrated vapour recovery in the nozzle

ZVA 25 GR, UTS hose assemblies

HD 100 C NEON, HD 10 C sensing hose

Type HD-C, aviation hose

Camlock cam locking couplings

top left – ELAFLEX standard version; bottom right – ELAFLEX EASYLOC version

Oasis NC 203 P30_P36 Nozzle Couplers

Elapharm EPH 25 with foodstuff fitting DIN 11551, free of dead spaces

ERV-W 80.16 ZS 2

White Band Rubber Expansion Joint with "ZS" limiter (tie rods with outer limitation in rubber bushings)

ERV-D

Rubber Expansion Joints Type ERV-D DN 200 - 4200, single or multi-sphere bellows. Here: DN 3600

ZVG 2 ACME nozzle for L.P. Gas / Autogas

visible: Magnet within the guard for the dispenser Reed Switch

Unloading: MK couplers with DDC-V 80 adapter

GasGuard LPG nozzles

and LPG 16 orange hose assemblies for the filling of commercial and passenger Autogas vehicles as well as mobile and small stationary storage tanks with propane and butane.

HB hot bitumen hose - loading plant

Rubber Expansion Joint ERV-CR 80.16

CR Expansion Joints for cold and warm water, swimming pool water, sea water, waste water (weakly sour or alkaline) also oil containing, cooling water with protective oils against corrosion, lubricating oil, grease and air, compressed air. Temperature range (depending on medium) - 25° C up to + 90° C, temporarily up to + 100° C. Electrically non-conductive.

GasGuard LPG nozzle GG1DN

suited for use by the general public and untrained personell (self service). Patented dual nose piece for added safety. Low lever actuation force. Gas release volume on valve closure: 1.7 cm³.

ELAFLEX refuelling equipment for CNG and LNG

FGN 2 SS

Flange with male thread, stainless steel

UTS hose assembly with AMKC 32 SS and AVKC 32 SS

'Camlock' stainless steel female and male coupling to EN 14420 - 7 with hose tail and Spannloc clamps

DDC-M 80-3" Ms

MannTek Dry Disconnect Coupling, DN 80, gunmetal

DDC-K 3" SS ADR

Pressure Cap, e.g. für LPG - Special type PN 25, ADR / RID compatible. With pressure indicator and pressure relief valve.

Rubber Expansion Joint ERV-GS HNBR 80.16

YELLOW STEEL HNBR expansion joints for petroleum based products, DIN EN fuels up to 50 % aromatic content, cooling water with oily anticorrosion additives, lubrication and hydraulic oil, seawater. Very good aging, weathering and ozone resistance. Temperature range (depending on medium) - 35° C up to + 100° C, temporarily up to + 120° C. Fire resistant to ISO 15540 up 30 min. at + 800° C. Electrically dissipative.